Teach Your Kid Electronics

Parts catalog

Every part used across the projects, grouped by type. Soon you'll be able to track what's in your own kit here and see what you still need.

Breadboards

Power

Wires

Resistors

Knobs (potentiometers)

LEDs

Switches & buttons

Capacitors

Transistors & diodes

Chips

  • 74HC08 AND gate chip

    Four AND gates: each output is on only when both of its inputs are on.

    14-pin DIP, 2–6 V

    Used in: Logic Gate Puzzles

  • 74HC32 OR gate chip

    Four OR gates: each output is on when either input (or both) is on.

    14-pin DIP, 2–6 V

    Used in: Logic Gate Puzzles

  • 74HC74 flip-flop chip

    Two D flip-flops: tiny memories that each store one bit (on or off).

    14-pin DIP, 2–6 V

    Used in: Flip-Flop Memory, Quiz Buzzer, Clap-On Light

  • 74HC86 XOR gate chip

    Four XOR ("exclusive or") gates: each output is on when exactly one input is on.

    14-pin DIP, 2–6 V

    Used in: Logic Gate Puzzles

  • CD4017 decade counter

    Counts clock pulses and turns on one of its ten outputs at a time, in order. Made for LED chasers.

    16-pin DIP, 3–15 V

    Used in: LED Chaser, Traffic Light Controller, Electronic Dice, Reaction Timer Game

  • CD4511 7-segment decoder

    Turns a number in binary into the right segments of a 7-segment display, and powers them brightly.

    16-pin DIP, 3–15 V, 25 mA per segment

    Used in: Two-Digit Counter

  • CD4518 dual decimal counter

    Two counters that count 0 to 9 in binary, then start again. Perfect for driving number displays.

    16-pin DIP, 3–15 V

    Used in: Two-Digit Counter

  • CD4520 dual binary counter

    Two counters that count 0 to 15 in binary. Same pins as the CD4518.

    16-pin DIP, 3–15 V

    Used in: Binary Counter

  • DRV8833 motor driver module

    A small board that drives two motors forwards and backwards from four input signals.

    2.7–10.8 V, 2 channels, breadboard pins

    Used in: Wired RC Car

  • LM358 dual op-amp

    Two amplifiers in one chip. With two resistors it can make a tiny signal 100 times bigger.

    8-pin DIP, 3–32 V

    Used in: Clap-On Light

  • LM386 audio amplifier

    Makes a weak sound signal strong enough to drive a speaker.

    8-pin DIP, 4–12 V

    Used in: Loudspeaker Amplifier, AM Radio

  • LM393 comparator chip

    Compares two voltages and switches its output depending on which is higher. Has two comparators inside.

    8-pin DIP, 2–36 V

    Used in: Fever Alarm, Clap-On Light

  • MK484 AM radio chip

    A whole AM radio receiver in a 3-legged package that looks like a transistor. TA7642 is the same chip.

    TO-92, 1.1–1.8 V

    Used in: AM Radio

  • NE555 timer chip

    One of the most famous chips ever made: it makes blinks, beeps and timers from a resistor and capacitor.

    8-pin DIP, 4.5–16 V

    Used in: 555 Blinker, Light Theremin, 555 Tone Keyboard, Binary Counter, Two-Digit Counter, LED Chaser, Traffic Light Controller, Electronic Dice, Reaction Timer Game, Loudspeaker Amplifier

  • PC817 optocoupler

    An LED and a light sensor sealed in one tiny chip, so two circuits can talk using light.

    4-pin DIP

    Used in: Light Messenger

  • ULN2003 driver chip

    Seven strong switches in one chip, with protection diodes built in. Small signals switch motors and lights.

    16-pin DIP, 500 mA per output

    Used in: Robot Muscles

Sensors

  • 10 kΩ NTC thermistor

    A temperature sensor: its resistance drops as it warms up.

    10 kΩ at 25 °C, B ≈ 3950

    Used in: Fever Alarm

  • Electret microphone capsule

    A tiny round microphone with two legs. The leg joined to its metal case is −.

    6–10 mm, 2 pins

    Used in: Clap-On Light

  • Light sensor (LDR / photoresistor)

    A resistor that changes with light: lots of resistance in the dark, little in bright light.

    GL5528 or similar, 5 mm

    Used in: Night Light, Light Theremin

Sound

  • Active buzzer, 5 V

    Beeps all by itself when you connect it to a battery. Long leg is +. (A "passive" buzzer only clicks.)

    12 mm, 3–5 V, ~30 mA

    Used in: Doorbell Buzzer, Steady-Hand Game, Rain Alarm, Tripwire Alarm, Reaction Timer Game

  • AM ferrite rod antenna coil

    A coil of copper wire on a dark magnetic rod. It picks up AM radio waves.

    About 200–500 µH, for AM (medium wave)

    Used in: AM Radio

  • AM tuning capacitor

    A capacitor with a knob: turning it picks the radio station. Often sold together with the antenna coil.

    Variable, about 10–270 pF (polyvaricon)

    Used in: AM Radio

  • Passive buzzer

    A tiny speaker. It needs a fast on-off signal (like from a 555 chip) to make a tone.

    12 mm, ~16 Ω

    Used in: Light Theremin, 555 Tone Keyboard, Loudspeaker Amplifier

  • Small speaker, 8 Ω

    Louder and better-sounding than a passive buzzer for music and radio.

    0.5 W, 8 Ω, about 40 mm

    Used in: Loudspeaker Amplifier, AM Radio

Motors & wheels

  • 2-wheel robot car chassis

    A flat base with two TT motors and wheels, plus a little swivel wheel at the front. Thick cardboard works too.

    2WD kit with TT motors

    Used in: Wired RC Car

  • TT gear motor

    The yellow motor used in robot cars. Runs on 3–6 V.

    3–6 V, ~200 mA running

    Used in: Spinning Fan, Robot Muscles, Wired RC Car

From around the house

  • Aluminum foil

    Kitchen foil conducts electricity. Great for making touch pads.

    Used in: Touch Switch

  • Modeling clay or play-dough

    Two lumps make great stands to hold wire shapes up off the table.

    Used in: Steady-Hand Game, Tripwire Alarm

  • Paper towel

    Holds water between the rain sensor wires.

    Used in: Rain Alarm

  • Piece of cardboard

    A base to tape things onto.

    Used in: Touch Switch, Spinning Fan

  • Ping-pong ball

    Cut in half, it makes a great light diffuser for mixing LED colors.

    Used in: Color Mixer