Beginner · Project 7
Doorbell Buzzer
Make a doorbell that buzzes when you press the button, and learn how a buzzer turns electricity into sound.
Build this only with an adult present. Before you start, read our safety notice and disclaimer.
🧰 What you need
- 1×Half-size breadboardA board full of little holes with metal clips inside, so you can build circuits without soldering.
- 1×3×AA battery holder with wire leadsHolds three AA batteries in a row and gives you a red (+) and black (−) wire.
- 3×AA batteryA regular household battery. Each one gives 1.5 volts.
- 1×Active buzzer, 5 V — must be an active buzzerBeeps all by itself when you connect it to a battery. Long leg is +. (A "passive" buzzer only clicks.)
- 1×Push button (tactile switch)A little button with 4 legs. It connects its two sides only while you press it.
- 3×Jumper wireA short wire with stiff ends that push into the breadboard.
✨ The finished project
🔣 New schematic symbols
This project’s schematic has some symbols you haven’t seen before. Here’s what they mean.
- Buzzer
A box with sound waves coming off it. The + marks the leg that goes toward the battery’s + side.
Ding-dong! (Well, more like bzzzzt.) This one’s quick: a button and a buzzer make a real working doorbell.
Meet the buzzer
Inside a buzzer is a thin disc of special material that bends a tiny bit when electricity goes through it. Make it bend back and forth thousands of times a second, and it pushes the air. That’s sound!
Like an LED, a buzzer has a + leg (the longer one, and there’s often a + printed on top) that must face the battery’s +.
Build it
Red wire: T+3 (top red + rail, column 3) to a3.
Buzzer: long (+) leg in e3, short leg in e6. Peel off the sticker on top if it has one; it makes it louder.
Blue wire: a6 to a8.
Push button: across the middle gap, with legs in e8, f8, e10 and f10.
Black wire: a10 to T-10 (top blue − rail, column 10).
Power: battery red wire into T+1, black into T-2. Press the button: BZZZT! 🔔
Why no resistor this time?
An LED would let as much current through as the battery can push, so it needs a resistor to protect it. An active buzzer has its own little circuit inside that only takes the current it needs (about 30 mA). So it connects straight to the battery, with just the button in the loop.
Not working?
- Only a tiny click? It’s a passive buzzer. You’ll need an active one for this project. Save the passive one for the timer projects in the Intermediate level!
- Silence? Check the buzzer’s long leg is in e3, toward the battery’s +. Active buzzers don’t work backwards.
- Buzzes all the time? The button is turned the wrong way. Give it a quarter turn (remember Push-Button Light?).